Copyright © 2019–2022 EXFO Inc. All rights reserved.
26/30
Replacing the Battery
8.
Push the new battery toward the bottom of the case until it stops.
9.
Ensure that the battery’s wires are
above
the plastic tab (not under),
and then connect the battery’s connector to the corresponding socket.
10.
Place the back panel on the unit, making sure that it is aligned properly
with the front of the unit. The sides of the back panel should be flush
with those of the front. There should be no gap between the back
panel and the front of the unit. If necessary, slightly move the back
panel until alignment is correct.
11.
Using a 2.5 mm hex socket screwdriver, turn the screws (4) clockwise
until they are tightened.
This will secure the back panel into place.
I
MPORTANT
To allow the unit to take into account the new battery, reset the
battery information as explained hereafter.
Battery
Battery’s wires
Battery’s connector
Plastic tab
