4
PANEL LAYOUT
7
6
1
8
9
CONTROL FUNCTIONS
BRIDGE 2 Min
INPUT
OUTPUT
LEFT
RIGHT
HPF
10Hz-1KHz
GAIN
MIN MAX
BOOST
0-12dB
LPF
50Hz-5KHz
REMOTE
HPF BPF
FULL
2500 WATT x 2CH FULL RANGE STEREO AMPLIFIER
3
Connect this Terminal with proper 0 GA size OFC Power Cable through a Fuse to the positive
Terminal of the car battery or the positive terminal of an isolated external car audio battery.
Always protect Power Cable via Fuse less than 12inch (30cm) from battery terminal.
SXA Amplifiers need external Fuse not less than 12inch (30cm) from Power terminal.
Note: Please follow the maximum Fuse recommendation from Excursion SXA Specifications.
Note: We designed 0GA Terminal to fit Hollywood ENERGETIC HPST (MULTE IN) Adapters.
Connect your speaker or subwoofer to these terminals with proper polarity.
Minimum OFC speaker cable required 10GA, 8GA OFC strongly recommend.
Never short cut or connect cables with chassis ground, effect short circuit and damage amplifier.
WARNING:
WARNING:
14. (+)12 Volt Battery Terminal RCA Audio
15. Speaker Terminals
Installation of the amplifier should be done in the following steps:
1. Ensure that the ground is appropriate, then connect it to the amplifier.
2. Next step is to connect the +12V wire. Ensure all power terminals are used.
This cable has to be fused for safety precautions.
3. The final step is connecting the switched remote.
CAUTION
Before attempting to make any connections to power supply, input and output connectors,
make sure the amplifier is in OFF state. Check polarity of cables carefully as using reversed
polarity will cause damage to amplifier. And to prevent power loss and overheating of wiring,
always use the recommended wire gauges.
CAUTION
2
4
5
13
12
14
15