6- ENG
A00732
ASSEMBLY INSTRUCTIONS
NOTE:
The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
5.
Connect wand to gun. Tighten
securely.
4.
Attach high
pressure hose to
gun. Tighten
securely.
1.
Place the nozzle holder onto the
panel (located on the handle
assembly) and push each nozzle
holder into place.
2.
Remove five colored quick
connect nozzles from plastic bag
and insert them into correct
grommet on the nozzle holder.
NOTE:
Nozzles are color coded to
match colored nozzles on panel.
3.
Place handle assembly onto frame,
depress the snap buttons, and slide
the handle assembly onto the frame
until snap buttons snap into place.
CARTON CONTENTS
Engine Frame
and Wheel
Assembly
High Pressure
Hose
Spray Gun
Quick Connect Spray Wand
Handle
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
7.
Using a 17 mm
wrench, remove
shipping plug from
pump by turning it
counterclockwise.
Discard plug.
8. Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
6.
Slide the formed rubber covers
onto the handle's on-board hose
and wand storage.
Chemical
Hose
English/
Spanish
Operation
Manual
Bagged Parts
Nozzle
Cleaning
Tool
Engine
Manual
Quick
Connect
Nozzles
Nozzle
Holder
Formed
Rubber
Covers
