Excalibur AL-2020-EDP, Руководство по эксплуатации

Страница: 6 / 28

6
Controller & Transmitter Functions (cont’d)
TRunK RELEASE / CHAnnEL 2: Press the “TRUNK” button for 3
seconds�
ThE SYSTEM WILL DISARM AND ThE TRUNK WILL •
OPEN (IF EqUIPPED)�
UPON RECEIVINg CONFIRMATION FROM YOUR •
SYSTEM, ThE CONTROLLER WILL PLAY ThE TRUNK
RELEASE ANIMATION AND BEEP TWICE
(1-way transmitter: press anD holD the trunk
button for 3 seConDs)
REMOTE START:
Press and release the “ ” button twice within 5
seconds� (see user feature #21 for additional options)
ThE PARKINg LIghTS WILL FLASh ONCE AND ThE •
STATUS LIghT WILL FLASh RAPID gREEN�
ThE SYSTEM WILL TURN ON ThE IgNITIONS AND •
PROCEED TO START ThE ENgINE�
ONCE ThE ENgINE IS RUNNINg, ThE PARKINg •
LIghTS WILL TURN ON AND STAY ON AND ThE STATUS
LIghTS WILL FLASh SLOW gREEN�
UPON RECEIVINg CONFIRMATION FROM YOUR •
SYSTEM, ThE CONTROLLER WILL PLAY ThE REMOTE
START ANIMATION AND PLAY A MELODY�
ThE CLOCK WILL ChANgE TO 0:00 TO START ThE •
REMOTE START TIMER� IT WILL TIME hOW LONg ThE
ENgINE RUNS IN MINUTES & hOURS�
( 1-way transmitter: press the start button
twiCe in 5 seConDs)
*
If the engine stalls, the system will make up to 3 more attempts� •
Each time you park your vehicle, set the climate controls to give you the de- •
sired interior temperature when you use the remote start�
The engine will run for the preset run time (see user feature #22)�
Run Time Extender • : Press the “ ” icon one time while in remote start mode
to restart the engine run timer� The timer on the controller will restart at “0:00”�
nOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
If you decide not to drive your vehicle, you can turn off the remote start using •
the same method to turn it on (Default = press “start” twice in 5 seconds)
nOTE: If user feature #21 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
Upon entering the vehicle during remote start mode, turn the ignition key to •
the “ON/RUN” position ( nOT START!! )� When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over�
*
x2