Excalibur AL-1670-B, Руководство по эксплуатации

Страница: 8 / 24

It is typically recommended that vehicles equipped with turbocharged engines allow the
engine to idle after driving to cool the turbocharger� When Installer Programmable Feature
#10 is ON, the system will automatically keep the engine running as follows:
• With the engine running, hold the brake pedal and engage the parking
brake� When the brake pedal is released, the system will keep the engine running for the
programmed time (1, 2, or 3 minutes)�
• Turbo Timer can be bypassed by turning the engine off before engaging the parking
brake� If it’s already engaged, step on the brake pedal to turn the engine off�
TURBO TIMER MODE
PIT-STOP MODE
XL PIT-STOP MODE
This feature allows you to leave your engine running for making quick errands� To use
this feature, have the engine running normally from the ignition switch and your foot off the
brake pedal. Press the Valet Switch twice; the parking lights will flash and the ignitions will
turn on� Turn the key off and the engine will remain running for the programmed run time�
Run time extender can be used in this mode�
This feature allows you to leave your engine running for making quick errands� To
use this feature, have the engine running normally from the ignition switch and your foot
off the brake pedal. Press the Valet Switch 6 times; the parking lights will flash and the
ignitions will turn on� Turn the key off and the engine will remain running for 12hrs� Run
time extender can be used in this mode allowing a run time up to 24hrs� This is ideal for
commercial refrigeration trucks, cleaning vans, vehicles w/ PTO, etc�
LOW BATTERY/LOW TEMP AUTOMATIC STARTING
Other Remote Start Features
This feature will automatically start the engine if the vehicle battery drops below
11 volts or the interior temperature drops to 15 (or 32) degrees fahrenheit� You must
activate these features each time you park your car to use them�
Method 1 - Valet Switch
• Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds
press the valet switch twice� If there is a 2 second delay without additional valet button
presses, the siren will chirp 3 times activating low voltage start mode�
• To activate low temp starting, enter low voltage start mode as described above then,
immediately after the horn honks, press the valet switch 1 time (15 degrees) or 2 times
(32 degrees) within 5 seconds. The siren will chirp to confirm your selection.
Method 2 - With The Controller (Low Volt & Low Temp. @ -15°F Only)
• Within 5 seconds, press UNLOCK, LOCK, START� The siren/horn will chirp to
confirm.
NOTE:
When low temp start mode is activated, low voltage start is also activated� These
features will operate once every two hours until the ignition key is turned “ON”�
8