10
Safety
english
r) Secure the workpiece.
A workpiece supported by
pipe holders is held more secure than by hand.
s) Always wait until the machine has come to
a complete stop before placing it down.
The tool
insert can jam and lead to loss of control over the
power tool.
t) Never use the machine with a damaged cable.
Do not touch the damaged cable and pull the
mains plug when the cable is damaged while
working.
Damaged cables increase the risk of an
electric shock.
Additional speci
fi
c safety rules
The pipe saw must never be used in the following
cases, if:
• There is water or another liquid, explosive gases or
poisonous chemicals inside the pipe to be cut.
• The power switch is faulty.
• The power cable is faulty,
• The blade is bent.
• The blade is blunt or in poor condition.
• The plastic components are cracked or have parts
missing.
• The gripper unit is not properly tightened around the
pipe or if it is warped.
• The blade guard cover or moving blade guard has
been damaged or removed from the machine.
• The locking mechanisms do not work properly
(UNLOCK-button).
• The pipe saw has become wet.
When using the pipe saw, the following factors
must always be taken into consideration:
• Support tubes to minimise the risk of blade
pinching.
• Ensure that the pipe to be cut is empty.
• Ensure that the blade is correctly installed.
• Ensure that the diameter and thickness of the blade
are suitable for the pipe saw and that the blade is
suitable for the rpm-range of the machine.
• Never use sideways force to stop the blade, always
allow the blade to stop freely.
• Check the attachments of the blade guards.
• Never use excessive force when using the pipe
saw.
• Never use the pipe saw to lift the pipe while it is still
attached to the pipe.
• Avoid overloading the electric motor.
• Always follow the safety and operating instructions
and current regulations.
Functional Description
Read all safety warnings and all
instructions.
Failure to follow the warnings
and instructions may result in electric shock,
fi
re and/or serious injury.
Intended Use
PipeCut V1000:
The Exact Pipe Cut V1000 is intended for professional
use at any kind of construction sites. The Exact
Pipe Cut V1000 is designed to be used only for thin
walled ventilation ducts with a diameter of 75 mm
(3”) - 1000 mm (40”).The maximum wall thickness that
the Exact Pipe Cut V1000 can cut through is 0,08’’
(1,5 mm). With a spiral ventilation duct the maximum
thickness of the seam that the Exact Pipe Cut V1000
can cut through is 6 mm (0,24”). With the Exact PipeCut
V1000 you can cut ducts made from the following
materials: galvanised steel, stainless steel, aluminium
and all kinds of plastic PipeCut V1000 pipe saw is
intended for short, intermittent use. The machine may
be loaded for 2,5 minutes during a 10-minute period
(S3 25 %). PipeCut V1000 pipe saw is not intended for
use in industrial production.
Product Features
While reading the operating instructions, unfold the
graphics page for the machine and leave it open. This
page is folded under the cover of this manual (page 3).
The following numbering of the product features refers to
this illustration.
Figure A
1. UNLOCK
button
2. Power
switch
3. Power-switch locking lever
4. Motor
unit
5. Blade-guard
cover
6. Straight adjustment screw
7. Edge of moving blade-guard
8. Sight
9. Operating
handle
10. Blade-guard screw
11. Spindle-lock button
12. Allen key
13. Rating-plate
14. Overload protection
15. Straight adjustment screw inicator
16. Steering unit
17. Safe for the steering unit
18. Steering unit indicator
19. The knob for the steering unit
