Exabyte VXA-2 AUTOPAK1X7, Руководство по эксплуатации продукта, Страница: 23 / 104

O
CTOBER
2002 E
XABYTE
VXA-2 A
UTO
P
AK1x7
A
UTOLOADER 15
P
OWERING ON THE
A
UTOLOADER
4.
4. 4.
4. If the autoloader is not the last device on the bus, connect a SCSI cable from
the unused SCSI connector to the next device on the bus, as shown in
Figure 2-7 .
P
OWERING ON THE
A
UTOLOADER
1.
1. 1.
1. Make sure that the power switch on the back of the autoloader is off (the
0
is pressed).
2. 2. 2. 2. Connect the female end of the power cord to the power connector on the
back of the autoloader (see Figure 2-8 ).
Figure 2-7 Connecting the autoloader to the SCSI bus (autoloader does not
terminate the bus)
From host
To next device
Important
Two power cords are shipped with the autoloader: One for
use in the US and Canada, and one for use in Europe. Use the
correct power cord for your location. See page 84 for power
cord requirements for other locations.