Exabyte 221L, Руководство по эксплуатации продукта

Страница: 148 / 208

132
P
RODUCT
M
ANUAL
1014258
C
HAPTER
6—U
SING THE
R
EMOTE
M
ANAGEMENT
U
TILITY
4.
4. 4.
4. Click on Continuously cycle a solenoid. A page similar to Figure 6-43
appears.
5. 5. 5. 5. Click on the radio button next to the solenoid you want to test.
6. 6. 6. 6. Specify the number of cycles for the test.
7. 7. 7. 7. Click on the Test Solenoid button.
Note: To stop a test in progress, click on the Stop button.
8. 8. 8. 8. When finished, return the library to its original control mode.
I
SSUING
T
APE
D
RIVE
C
OMMANDS
You can issue the following tape drive commands:
Clean a tape drive – Cleans the tape drive by inserting a cleaning cartridge
into the drive and removing the cartridge when the cleaning is finished.
Unload a tape drive – Unloads a cartridge from the tape drive.
Cleaning a Tape Drive
If a tape drive requires cleaning and you are not using the library’s Autoclean
option (see page 107 ), you can issue a command to clean the tape drive using a
cleaning cartridge stored in the library.
To use this cleaning method, make sure that you have:
Installed a cleaning cartridge in the appropriate slot. See page 16 .
Activated the cleaning cartridge slot. See page 107 .
Specified the number of cleaning cycles available on the cleaning cartridge.
See page 107 .
Turned off the Autoclean Option. See page 107 .
Figure 6-43 Remote management utility – Solenoid Diagnostics page