Ex-Cell VR2500, Руководство по эксплуатации

Страница: 9 / 16

9- ENG
A08955
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
When using the high pressure setting, DO NOT allow the high
pressure spray to come in contact with unprotected skin, eyes,
or with any pets or animals. Serious injury can occur.
Your washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician
immediately!
NEVER fill fuel tank when engine is running or hot. Do not
smoke when filling fuel tank.
NEVER fill fuel tank completely. Fill tank to 1/2" below bottom of filler neck
to provide space for fuel expansion. Wipe any fuel spillage from engine and
equipment before starting engine.
NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly gas.
DO NOT
let hoses come in contact with very hot engine muffler during or
immediately after use of your pressure washer. Damage to hoses from contact with
hot engine surfaces will NOT be covered by warranty.
NEVER
pull water supply hose to move pressure washer. This
could damage hose and/or pump inlet.
DO NOT use hot water, use cold water only.
NEVER turn water supply off while pressure washer engine is running or damage to
pump will result.
DO NOT stop spraying water for more than two minutes at a time. Pump operates
in bypass mode when spray gun trigger is not pressed. If pump is left in bypass
mode for more than two minutes internal components of the pump can be
damaged.
If you do not understand these precautions, please call
1-800-888-2468
to
speak to a service representative for further instructions.
NOTE: For every 7 gallons
of water pumped 1 gallon of
chemical/cleaning solution will be
used.
3. Set multi-adjustable nozzle to
low pressure setting. See How
To Use Wand paragraph in this
section.
4. After use of chemicals,
place
chemical hose into container
of clean water and draw
clean water through chemical
injection system to rinse
system thoroughly. If chemicals
remain in the pump it could be
damaged. Pumps damaged due
to chemicals will not be covered
under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
HOW TO APPLY
CHEMICALS/CLEANING
SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use. Do
not use bleach.
To Apply chemicals:
1. Press chemical
hose onto
barbed fitting
located near high
pressure hose
connection of pump as shown.
2. Place other end of chemical
hose with filter on it into container
holding chemical/cleaning
solution.
Barbed Fitting