EWT CS 4 COMFORT, Руководство оператора

Страница: 35 / 120

35
GENERAL ASSEMBLY INSTRUCTIONS
GENERAL ASSEMBLY
1. Make sure that it is not plugged into the mains. (Fig. 1)
2. Undo the 2 container clasps which hold the upper part. (Fig. 2)
3. Lift off the upper part. (Fig. 3)
4. Remove the accessories from the container. (Fig. 4)
5. Replace the container and insert the 2 feet with rollers. Check that they are pushed in correctly (Fig. 5a).
6. To assemble the 2 large notched wheels; slide the bar which will hold the two wheels in the corresponding
location on the bottom of the vacuum cleaner. Place a washer, then the wheel, then another washer on
the other side of the wheel. Fasten by threading the hook into the hole located on the bar. Finally, fit the
orange wheel cover (Fig. 5b).
7. For dry vacuuming, install the supplied cartridge filter and dust bag (Fig. 6, Fig 7).
8. For wet vacuuming, install the supplied foam filter (Fig. 8).
9. Align the top section with the clasps, and snap into place by applying pressure until clasps latch into
place (Fig. 9).
10. Hook the clamps into the upper section and let them snap into place by pressing the clamps downwards
(Fig. 10).
11. Place the large end of the hose on the front air intake stub on the tank (Fig. 11).
12. Choose the desired accessories and push onto the suction tube (Fig. 12).
13. Use the air-leak slider that is included on the handle section (Fig. 13).
14. Plug the power tool into the “Integrated Socket” on the vacuum cleaner. Plug the vacuum cleaner into
the mains (Fig. 14).
15. After using and cleaning the appliance, store the accessories by attaching them to the corresponding
holders on the vacuum cleaner (Fig. 14).
4
2 3
9
5a
6
5b
1
8 7
10 11 12 13 14