EVVA e-primo, Руководство пользователя

Страница: 22 / 89

24
Electronic cylinder
Installing the e-primo cylinder
Please note that it may not be possible to open the door
again after it is closed because the outside thumb turn will
rotate passively, i.e. without engaging. After installation –
but before closing the door – insert a battery (see “Battery
insertion/replacement“), program the e-primo cylinder and
test its functionality. The e-primo cylinder can now only be
opened with a valid identiication medium.
Should problems arise during installation, please contact
your dealer or visit our website on the Internet at
www.evva.com/e-primo
1
Loosen (turn clockwise) the outside thumb turn‘s ixing
screw with the special ZTOOL1 Allen wrench and pull it off.
2
Rotate the outside thumb turn such that the outer loca-
ting screw is in the area of the cylinder proile.
3
Push the e-primo cylinder by hand, from inside to out -
side, through the escutcheon and the mortise lock (loosen
the escutcheon‘s fastening screws if necessary).
4
Fasten the e-primo cylinder in the mortise lock with the
cylinder ixing screw. The cylinder ixing screw should be
tightened down to a torque of 2 Nm (now also re-tighten
the escutcheon‘s fastening screws if necessary). Place the
gasket into the groove.
Notice: The speciied IP rating is only achieved when
the gasket is in place.
5
Carefully push the outside thumb turn cover to its limit
onto the e-primo cylinder. The outer locating screw must
be engaged in the guide groove. Fasten the outside thumb
turn by carefully screwing in (turn counter-clockwise) its
screw with the special ZTOOL1 Allen wrench.
Important: Please assign a programming key and a
user key to the cylinder and make sure a functional
battery is inserted before closing the door!