EVS Synapse GED100, Руководство пользователя

Страница: 34 / 74

#EmbA1_Phase ~
#EmbD4_Phase Adjusts the audio phase of the corresponding individual input to 0 degrees or
180 degrees.
#EmbA1_Delay ~
#EmbD4_Delay Adjusts the delay of the corresponding audio channel between 0 and 5000ms.
5.10. Misc.
Setting Description
NonPCM-Bypass With this setting you can switch to bypass audio processing for all non-PCM audio
On or Off .
Fade-Time Fade/time is locked to 2 parameters: channel-switch and gain-change. It is used as
the fade-in/out time of the channel-switch of audio channels. The old channel will
be faded out and the new channel will be faded in according to the time chosen
with fade-time. Fade-Time is also used for smooth transitions when gain-values or
presets are changed. These smooth transitions are triggered by a change in Gain
settings or a Preset change. With this setting you can manually set this fade time
between 0ms and 10,000ms. The default is 400ms.
Audio-Phase If this setting is set to Align , the card ensures audio-phase alignment between
multiple audio channels and audio groups, which is necessary for multi-channel
(surround) purposes. If errors in the signal-chain occur, the de-embedder blocks
reset synchronously to maintain audio-phase alignment.
If this setting is set to Off , the card eats-all audio including errors. Even if there are
DBN/ANC/ECC or channel-sequence errors, the de-embedder will pass them. Be
aware that audio-phase alignment between multiple audio channels and audio
groups cannot be maintained if this setting is set to
Off .
This setting can be helpful to solve problems in the field using equipment which doesn’t
follow the standards correctly.
AudioStatusBits With this setting you select whether the audio status bits should be Transparent
(same status bit on the outputs as on the inputs) or to overwrite them with new
status bits.
Silence-Level Here you set the threshold of the audio level when an audio signal will be reported
as silent. Can be set between -100dBFS and -20dBFS. Default is -60dBFS.
Silence-Time Here you can set the threshold in time when an audio signal will be reported as
silent. Can be set between 1 and 255 seconds. Default is 10 seconds.
26 | November 2021 | Issue 1.00.B