EVS SYNAPSE DIO48, Руководство по установке и настройке

Страница: 17 / 32

EVS Broadcast Equipment SA
15
Silence-time
The DIO has a silence detection built in. With this setting you
decide how long a silence should be before it is detected and
alerted as a silence. Can be anywhere between 1 and 254 seconds.
Default is 1 second.
Silence-level
This item decides at what volume level a silence should be
detected. Can ben anywhere between -20 and -100 dBFS. Default
is -40 dBFS.
Note:

When a silence is detected (conform the above 2 setting items) it
is indicated by the status items
Audio-A1
till
Audio-B4
individually. This can also be alerted using the events menu.
 Silence events are only triggered if the setting
Sil-Det-Xx
for
that specific channel is set to
on
. Status items
Audio-A1
till
Audio B4
will always indicate silence detections conform
these settings, despite
Sil-Det
being switched on or off.
 Silence detection is done after the input mux and before the gain
and phase processing.
SourceA1 ~
SourceA4
SourceA1
till
SourceA4
allow you to select what the source
inputs should be. The possible settings differ for each mode. These
are the possibilities per mode:

Dig-Emd
mode: the local input channels
Aes1L
till
Aes4R
are possible.

Dig-di
g mode: the local input channels
Aes1L
till
Aes4R
are possible.

Deemb-Emb
mode: the local input channels
Aes1L
till
Aes4R
and Add-on output channels
Add_on1
till
Add_on4
are possible.

Deemb-dig
mode: the local input channels
Aes1L
till
Aes4R
and Add-on outputs channels
Add_on1
till
Add_on8
are possible.
Modes are set in the setting
In_Out
. The default settings for
SourceA1
till
sourceA4
are respectively
Aes1L
till
Aes2R
Note:
in
Deemb-Emb and Deemb-dig
mode it is possible to
make a selection and combine local channels with ADD_ON
channels.
Note: If
Deemb–Dig
or
Deemb-emb
modes are set,
ADD_ON1
till
Add-On4
are the required settings if you want to use the card
for deembedding.