Evoqua WALLACE & TIERNAN DEPOLOX 5 E 700 P Series, Инструкция по эксплуатации

Страница: 44 / 82

44
WT.050.810.040.DE.IM.0519
Installation
DEPOLOX
®
5 E flow cell
4.
4.4.13 Connecting sensors with DFMe electronics module
Proceed as follows:
1 Insert the multi-sensor (A) in the flow control valve (B).
2 Connect sensor cable DFMe-DES (E) to the 3-electrode measuring
cell (C). To do this, screw cap (D) on the
3-electrode measuring cell (C) counterclockwise up to the mark (see
Image 10, item K) and take it off. Feed the sensor cable through the
cap and tighten with the M12 cable union (L). Connect the signal
cable, observing the correct colors (see Image 11 and lower table).
Screw in the cap clockwise up to the mark.
3 Insert or screw the LED glow stick (F) into the mounting hole in the
cell body cover.
4 Connect the pH- and redox sensor cable plug (G, H) with the pH and
redox combined measuring and reference electrode.
5 Plug the CAN connection cable into the CAN connection socket (J)
and with connect with 700 P electronics module or 700 M electronics
module (CAN socket).
Image 12Cross-section of DEPOLOX
®
5 E flow cell, non-pressurized
version
Image 13Cross-section, DFMe electronics module
A Multi-sensor
B Flow control valve
C 3-electrode measuring cell
D Cap
E Sensor cable DFMe-DES
F LED glow stick
G pH sensor cable (optional)
H Redox sensor cable (mV) (optional)
I CAN extension socket (optional)
J CAN connection socket to
electronics module
A E F G H
I
J
A
B
C
D
Image 10Detail: cap Image 11Section of 3-electrode
measuring cell
WRK Working electrode (Image 11, item M) Red point Red cable
CNT Counter electrode (Image 11, item N) Blue point Blue cable
Ref Reference electrode (Image 11, item O) White cable
K
L
M
N
O