3. Before Use the device
3.1 Removing the belt clip
Before insert batteries into the device, first remove the belt clip latch away from the device.
3.2 Installing and charging the Batteries
1, This Device use with lithium battery. Please only charging the default batteries.
2, After placing batteries into correct positions, replace the battery cover.
3, Insert USB cable to charging it. The full charging time is about 6 hours.
4. Using the device
4.1 Turning the device on/off
Switch on the device: Press and hold on the 3 seconds then you will hear a beep sound.
Switch off the device: Press and hold on the 3 seconds then you will hear a beep sound.
4.2 Adjusting the volume
There are 8 levels volume adjustable.
To increase the volume, press the Up
▲
button. And press the Down
▼
button to decrease
the volume.
4.3 Low Battery Indication
The device can detect the low battery level when the battery voltage goes low. When battery
voltage is low, the battery icon will flash and a beep will be heard to indicate that the
batteries need to be replaced.
4.4 Receiving/transmitting communications:
The devices are in “Reception” mode when it is turned ON and no transmitting. When a
signal is received on the current channel, the LCD will display in reception.
When you press the PTT (push to talk) button, the devices switches to “Transmission”
mode.
Hold the device in a vertical position with the Mic(microphone) 3-5cm away from your
mouth. While holding the PTT button, speak into the microphone in a normal tone of voice.
Release the PTT button when you have finished transmitting.
For others to receive your transmission, they must be on the same channel with you.
Note:
1, The talking range will depend on your surroundings and environment. It will be
affected by obstructions such as hills or buildings.
2, Don’t try to use two devices which are less than 1.5m (5 feet) apart. Otherwise, you may
experience interference.
4.5 Changing Channels
Press the MENU button one time, the channel number will flash on the display.
Press the up
▲
/down
▼
button to change the channel.
Press the PTT button to confirm and return to stand-by mode.
Note:
if no button is pressed within 10 seconds during setting, the device will return to
stand-by mode.
Содержание FreeTalk 2W
Страница 1: ...MANUAL MODEL FreeTalk 2W...