___________________________________________________________________________________________________________
ENG
EVOLVEO wireless movement sensor with a tamper protection and an integrated antenna
Installation
Remove the front cover and turn the "A" power sensor switch to "ON". Then attach the sensor holder to the wall and insert the
PIR sensor. A recommended ideal detector high is approximately 1.8 ~ 2.5 m while it should be tilted with the sensor to the
ground at an angle of 6° ~ 12° (from the vertical wall). Check the detecting radius and adjust the sensor according to your
needs.
1.
Switch on / Switch off (On/Off)
2.
The highest sensitivity
3.
Medium sensitivity
4.
Low Sensitivity
5.
Sensor selectivity, 3.3m
6.
Sensor selectivity, 1.5m
7.
Sensor delay setting (8 s/50 s/15 min.)
8.
Tamper protection
To avoid false alarms and to ensure the standard sensor functionality, place it far enough away from windows, air conditioning,
fans, refrigerators, stove, etc. These devices and windows can cause rapid temperature changes and interfere with the sensor
activity. Do not point the sensors to the sources of; expose them to drafts, install them outside the enclosure; attach them to a
solid wall with flat surface; protect them from the direct sunlight. If the sensor must be turned to the window, pull the
curtains before alarm activation or roll down the shutter to insure reliable PIR sensor operation. The active area of the sensor
can not be covered by any objects, such as indoor plants or furniture. The sensor is most sensitive to the cross movement, so
the direction of the sensor rotation should be at a particular angle to the protected area (corridor), as shown in picture 2.
Low battery detection and indication
When movement monitoring, the blue LED is lit. When the battery capacity is below 4.3V, the red LED flashes and the batteries
must be replaced.
Technical specification
Power supply: DC 6 V (2 pc, 3V CR123A battery)
Frequency: 433 MHz
Operating temperature: +10°C
～
+40°C
Humidity ≤ 90% rh
D. Key control (remote control)
Power supply: DC12V (inner 12V battery)
Transmission frequency: 433 ± 0,5 MHz
Copyright © 2014 ABACUS Electric spol. s r.o. , www.evolveo.eu
All rights reserved.
Design and specification can be changed without prior notice.
Printing errors reserved.
