Evolve GTS9, Руководство пользователя

Страница: 37 / 44

Important reminder
：
-Do not use sandpaper and solvents to clean the treadmill.
The controller part of the treadmill should not be directly exposed to the
sun or
KXPLGLW\
to avoid damage.
-Check and tighten all parts of the treadmill frequently. Damaged parts
must be replaced immediately.
-The running belt is the most vulnerable part in operation. Please replace
it in time when the running wear is serious.
1.1 Adjusting running has two functions: elasticity adjustment and center position
adjustment of the running belt. The running belt has been adjusted before leaving
the factory, but after use, the running belt will be stretched and it will deviate from
the center plate and cause the running belt to rub the decorative strip. It is normal
for the running belt to be stretched during use. If the running belt slips or is not
smooth when you use the treadmill, you can adjust the tightness of the running
belt to improve it.
1.2 How to adjust the running belt?
1) Insert a 6mm Allen key into the adjusting screw on the left side of the running
belt, and turn the wrench 1/4 turn clockwise to adjust the rear roller to tighten the
running belt.
2) Repeat step 1 to adjust the right screw. Make sure that the adjusting screw
rotates the same distance so that the roller will be adjusted parallel to the frame.
3) Repeat steps 1 and 2 until the running belt does not slip.
4) Note that the running belt cannot be adjusted too tightly. This will damage the
running belt, increase the pressure of the front/rear rollers, cause damage to the
roller bearings, etc., produce abnormal noise or other problems. If you want to
reduce the tension of the running belt, Please turn the wrench counterclockwise,
and the left and right sides of the note should be rotated the same.
"EKVTUUIFSVOOJOHCFMU
"EKVTUUIFSVOOJOHCFMUUPUIFNJEEMF
www.evolve-fitness.eu
36