Using EVOLVE 4000HD v2 Sport for Water Sports
Remind you to put some silicon grease to the rubber O-rings from time to time,
especially before using underwater. Make sure the rear cap ③ was closed tight.
UPOZORNĚNÍ
"O" ring
Silicon grease
Waterproof cap
OVERVIEW
①
LED
②
Power / Shutter
③
Rear Cap
④
Mode Switch
⑤
USB
⑥
Plug MicroSD Card Slot
⑦
Battery
⑧
Microphone
INITIAL SET UP
1.
Make sure the EVOLVE 4000HD v2 Sport is OFF before adding or removing the memory card!
2.
Screw out the rear cap (open) located at the back of the EVOLVE 4000HD v2 Sport
③.
3.
Install a micro SD memory card (max up to 32GB) into the rear slot. To insert the micro SD card, slide the
micro SD card into the card slot on the back of the EVOLVE 4000HD v2 Sport with the card label facing down.
The micro SD card will click into place once it is inserted past flush with the Bullet HD. Use your fingernail to
do this. Then screw in the rear cap till is complete lock
4.
If no micro SD memory is inserted in the Bullet HD, the LED on top of the camera will blink red and green.
5.
When using a micro SD memory card in the EVOLVE 4000HD v2 Sport, there should be no data from other
devices on the card. If you are using a micro SD memory card for the first time in the EVOLVE 4000HD v2
Sport, first you should format the card in your computer.
