Evolve 24C G.C., Инструкция пользователя, Страница: 3 / 68

3
1.1 GAS APPLIANCES
Gas Safety (Installation and Use) Regulation (UK).
In the interests of your safety and that of others it is a legal
requirement that all gas appliances are installed and correctly
maintained by a competent person and in accordance with the
latest regulations.
1.2 ELECTRICAL SUPPLY
Please ensure that this appliance has been properly connected
to the electrical supply by means of a double pole isolator or
un-switched socket, and that the correct size of fuse (3 AMP)
has been fitted.
Warning: this appliance must be earthed!
1.3 WARRANTY REGISTRATION
Please take the time to register the appliance warranty using
the documentation provided, call 0800 479 0754 (UK) or 056
7755055 to obtain your warranty confirmation code (please
have your appliance warranty card to hand).
1.4 APPLIANCE COMMISSIONING CHECKLIST
(UK only)
The Benchmark checklist section can be found at the rear of
the appliance installation booklet. This important document
must be completed during the installation/commissioning of
your boiler. All GAS SAFE registered installers carry a GAS
SAFE ID card, and have a registration number. These details
should be recorded in the Benchmark commissioning checklist
section within the installation booklet. You can check your
installers details by calling GAS SAFE direct on 08004085500.
Failure to install and commission the appliance in accordance
with the manufacturers instructions will invalidate the warranty.
This does not affect your statutory rights.
1.5 HOW DOES IT WORK?
Your evolve boiler supplies heated water to your radiators
and hot water to your hot water taps. The central heating is
controlled via a time clock and any thermostats that your installer
may have fitted. The boiler will light when it receives a request
from the time clock via any thermostat that may be installed, or
whenever a hot water outlet (tap) is opened. Your evolve boiler
lights electronically and does not have a pilot light.
In the unlikely event of a fault developing with your boiler, the
supply of gas to the burner will be terminated automatically.
USERS INSTRUCTIONS
Dear Customer
Your Vokèra evolve boiler has been designed to meet and exceed the very latest standards in gas central heating technology,
and if cared for, will give years of reliable use and efficiency.
Please therefore take some time to read these instructions carefully.
Do’s and Don’t’s
- Do ensure that the system pressure is periodically checked
- Do ensure that the boiler is not used by children or unassisted disabled people
- Do ensure that you know how to isolate the appliance in an emergency
- Do ensure that you are familiar with the appliance controls
-
Do
ensure that your installer has completed the appliance log book section
- Do not attempt to remove the appliance casing or gain internal access
- Do not hang clothes etc. over the appliance
-
Do not
forget to have the appliance serviced annually.
This booklet is an integral part of the appliance. It is therefore necessary to ensure that the booklet is handed to the person
responsible for the property in which the appliance is located/installed.
A replacement copy can be obtained online from www.vokera.co.uk & www.vokera.ie.
INTRODUCTION
1. THINGS YOU SHOULD KNOW
1.7 CLEARANCES REQUIRED
ABOVE 100mm*
BELOW 100mm^
LEFT SIDE 2mm
RIGHT SIDE 2mm**
FRONT 4mm***
evolve 24C - 28C 32C - 36C
HEIGHT 740 mm 740 mm
WIDTH 420 mm 420 mm
DEPTH 275 mm 350 mm
1.6 DIMENSIONS
* 100mm if rear-flue outlet is used or 25mm above flue bend if top
flue outlet is used. Consideration should be given to providing
reasonable clearance for the insertion of a FGA probe.
** Disconnection of adjacent components may be required in order
to facilitate syphon removal.
*** Provided that a door or removal panel enables 450mm access for
maintenance.
^ Can be reduced to 5mm if a removal panel enables 100mm for
maintenance.
100
25
2
2
100
1.8 FROST PROTECTION SYSTEM
The evolve is equipped with a built-in frost protection system,
this enables the boiler to over-ride the time controls – even if
switched off – and operate the burner and/or pump, should
the temperature within the appliance drop below 5 °C. Please
note that the frost protection system is designed to protect the
appliance only, should frost protection be required for the heating
system, additional controls may be required.
NOTE
The frost protection system is reliant on the appliance having a
permanent electrical supply, and being in a non-fault condition.
1.9 APPLIANCE STATUS INDICATORS
Your appliance incorporates the REC 10 UI (User Interface),
that displays information on appliance status and condition.