Evolution Rage3B2101, Оригинальное руководство пользователя

Страница: 6 / 28

6 www.evolutionpowertools.com
When fitted with a correct blade this
machine can be used to cut:
Wood, Wood derived products (MDF,
Chipboard, Plywood, Blockboard, Hardboard
etc), aluminium, Mild Steel
NOTE:
Wood containing non galvanised nails or
screws can, with care, be safely cut.
PROHIBITED USE OF THIS POWER TOOL
WARNING:
This product is a Multipurpose Sliding
Mitre Saw and must only be used as such. It must not
be modified in any way, or used to power any other
equipment or drive any other accessories other than
those mentioned in this Instruction Manual.
WARNING: This product is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning the safe use of
the product by a person responsible for their safety
and who is competent in its safe use.
ELECTRICAL DATA FOR EU COUNTRIES
IMPORTANT
This product is fitted with an electrical connection
plug that is compatible with the machine and,
the mains supply for your Country and meets
the requirements of international standards. This
machine must be connected to a supply voltage
that is equal to that stated on the rating label. If
the mains connection plug or mains supply lead
becomes damaged it must be replaced with a
complete assembly that is identical to the original.
If in doubt always consult a qualified electrician.
ELECTRICAL SAFETY
CONNECTION OF THE DOUBLE INSULATED
MAINS PLUG- UK ONLY
IMPORTANT:
The wires in the mains lead fitted
to this product are coloured in accordance with
the following code:
Brown:
Live (L) or Red
Blue:
Neutral (N) or Black
THIS PRODUCT IS DOUBLE INSULATED
AND THEREFORE DOES NOT REQUIRE A
CONNECTION TO EARTH.
• THE 3 PIN PLUG MUST COMPLY TO
BS1363/A.
• THE FUSE MUST COMPLY TO BS1362.
If for any reason the 13 amp moulded plug
fitted to this product requires replacing, the
replacement must be wired in accordance with
the following instructions:
• Connect the Blue wire to the terminal
marked Neutral (N).
• Connect the Brown wire to the terminal
marked Live (L).
ensure that the outer insulation is gripped by
the cord grip and that the wires are not trapped
when replacing the plug cover.
a 13 amp (BS1362) fuse must be fitted in the plug.
Do not connect any wire to the earth pin
MaRKeD e on the 3 pin plug.
If in any doubt consult a qualified electrician.
There are no user serviceable parts inside this
product except those referred to in the manual.
always refer servicing to qualified service
personnel. Never remove any part of the casing
unless qualified to do so; this unit contains
dangerous voltages.
OUTDOOR USE
WARNING: For your protection if this tool is to
be used outdoors it should not be exposed to
rain, or used in damp locations. Do not place
the tool on damp surfaces. Use a clean, dry
workbench if available. For added protection
use a residual current device (R.C.D.) that will
interrupt the supply if the leakage current to