Evolution Rage 7, Оригинальное руководство пользователя

Страница: 10 / 16

10 www.evolutionbuild.com
®
SPECIFICATION
EVOLUTION BATTERY
JIGSAW & CHARGER
JIGSAW
Voltage: 18.0V-DC
No Load Speed: 0-2400 strokes per minute
Stroke Length:
25.4mm
Blade Type: T-shank
CHARGER
Input: 230-240V ~ 50/60 Hz
Output 18V DC, 1.7A
Charging Time: 1 Hour
BATTERY PACK
Battery Voltage: 18V
Battery Capacity: 1500 mAh
NOISE AND VIBRATION DATA
Sound Pressure: 87.3dB(A) K=3dB
Sound Power: 98.3dB(A) K=3dB
Vibration: 5.383m/s
2
K 1.5 m/s
2
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one
tool with another.
The declared vibration total value may also
be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during
actual use of the power tool can differ from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation of
exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
off, when it is running idle, in addition to
trigger time)
FUNCTIONAL DESCRIPTION
Note: Before using this tool, read the
instruction manual carefully.
BEFORE USE
A Battery Pack must be inserted into the
tool as detailed below. It is important that
the Battery Pack is of the designated type
recommended for this machine.
Newly purchased Battery Packs do
not come fully charged, and should be
charged before use.
Note:
Battery power and performance will
improve after several discharge/charging
cycles have been completed.
WARNING:
The battery pack and battery
charger supplied are specially designed
to work together. Do not attempt to use
any other charger or battery pack with this
Evolution Jigsaw.
CHARGING A BATTERY PACK
1. Position the charger on a work bench
or similar in a well ventilated location and
ensure that the charger cannot be covered by
workshop cloths etc.
2. Plug the charger into a suitable power
socket. The green LED will illuminate.
3. Slide the Evolution 18V battery pack into
the docking port of the charger. It will only fit
in one way round.
4. Firmly slide the battery pack down into the
charger to ensure terminal connection. The
battery locking tabs should positively engage
the charger. The red LED will light to confirm
terminal connection and that the charging
cycle has started. See Fig 1
5. When the green LED flashes, the charging
cycle is 90% completed.
6. Remove the battery pack from the charger
when the flashing green LED remains steady,
and store the charger safely for future use.
Remove the battery pack by pressing the two
locking tabs on either side of the pack and
slide the pack from the charger.