Evolution evotherm EFI Ultra V30T, Инструкция по установке и эксплуатации

Страница: 8 / 48

5
1.2. The Symbol Description of the Device
The precautions listed here are divided into the following types. They are quite important, so be
sure to follow them carefully. Meanings of DANGER, WARNING, CAUTION and NOTE symbols.
Symbols Meaning Description
WARNING
The symbol shows that this appliance uses a
flammable refrigerant.
If the refrigerant is leaked and exposed to an external
ignition source, there is a risk of fire.
WARNING
The symbol shows that this appliance uses a low
burning velocity material. Please keep away from fire
source.
CAUTION
This symbol shows that the operation manual should
be read carefully.
CAUTION
This symbol shows that a service personnel should be
handling this equipment with reference to the
installation manual.
CAUTION
This symbol shows that information is available such
as the operating manual or installation manual.
1.3. Statement
To keep users under safe working condition and property safety, please follow the instructions
below
：
①
Wrong operation may result in injury or damage;
②
Please install the unit in compliance with local laws, regulations and standards;
③
Confirm power voltage and frequency;
④
The unit is only used with grounding sockets;
⑤
Independent switch must be offered with the unit.
1.4. Safety Factors
The following safety factors need to be considered:
①
Please read the following warnings before installation;
②
Be sure to check the details that need attention, including safety factors;
③
After reading the installation instructions, be sure to save them for future reference.
Warning
Make sure that the unit is installed safely and reliably.

If the unit is not secure or not installed, it may cause damage. The minimum support weight
required for installation is 21g/
㎜²

If the unit was installed in a closed area or limited space, please consider the size of room
and ventilation to prevent suffocation caused by refrigerant leakage.
①
Use a specific wire and fasten it to terminal block so that the connection will prevent pressure
from being applied to parts.
②
Wrong wiring will cause fire.
Please connect power wire accurately according to wiring diagram on the manual to avoid
burnout of the unit or fire.