For Customer Assistance:
www.evolutionlightingllc.com
Made In China
Installation
1
Assembling the
lamp
2
Installing the mounting hardware
3
Installing the fixture
4
Installing the shade and light bulb
Place the shade (C) over the socket on the fixture assembly (A).
Install a 60 Watt Type A Bulb or CFL or LED equivalent (not included).
Carefully unpack and lay all parts on a clean, level surface.
Assemble all tubes (B) to the fixture assembly (A).
2.75in/7cm
BB
AA
Determine the desired location of the fixture making sure
you have access to an electrical outlet and there are no
electrical lines or plumbing where you intend to attach the
mounting hardware.
Mark the anchor (AA) locations on wall and drill
each hole 6 mm
in diameter
.
Insert the anchors (AA) and tap into the wall until secure.
Set two screws (BB) into the top anchors (AA) using a screwdriver,
leaving enough exposed to set into the keyhole slots on the fixture
assembly.
Align the keyhole slots on the fixture assembly (A) with the
screws (BB) on wall and then gently push the canopy toward the
wall and slide down until secure.
Attach the plastic clip (CC) to the appropriate location on the
bottom tube (B) and mark the outside edge of the plastic
clip (CC). Unthread the bottom tube (B) and move it away, drill a
hole 6 mm in diameter at the center of this marked location and
install the anchor (AA). Remove the pre-attached
plastic clip (CC)
from the bottom tube (B) and secure it to the anchor (AA) with
the short screw (DD).
Slide the bottom tube (B) through the plastic clip (CC) and thread
it to the assembled tubes.
