Evolution Technologies Safari Lite 4000, Руководство пользователя

Страница: 15 / 21

Evolut ion Sa fa ri Sc oot e rs
15
MAINTENANCE
Tires
Since your tires are flat free tires, there is no need to ever worry about tire air pressure.
General Maintenance and Lubrication
Inspection for loose wheel bolts, seat and arm tightening bolts, and other nuts and bolts is
recommended on a regular basis.
Most lubricated components on the Safari Lite 4000 Portable scooter are designed to be
maintenance free and are sealed. Therefore lubrication is not required for these components.
However, the driving axles and seat post should always have a very light coat of multipurpose
grease.
DO NOT USE TOO MUCH GREASE!
Drips may stain or damage carpets, furnishings, etc.
It is recommended that the driving axles (inside the drive wheel assembly) be checked and
cleaned occasionally for hair and debris build-up, which will hinder the performance of the unit.
Check the batteries on a regular basis. For extended battery life, it is highly recommended that
the batteries be fully charged after use. Please refer to battery section of this manual. If the
batteries are weak, severely discharged or old, a variety of problems may occur with the unit
including charging problems, reduced speed, loss of range, and others. Please contact your lo
cal
Evolution Technologies Inc. provider for battery replacement.
TROUBLESHOOTING GUIDE
Circuit Breaker (Reset Button)
Your scooter is fitted with the latest in electronic controls that are programmed to protect the
electrical system from abnormal overloads. Provided for extra protection is a circuit breaker,
located on the side of the battery pack. Should there be a situation where your scooter stops for no
apparent reason, please check that the circuit breaker has not popped.
NOTE: To preserve battery charge, your scooter may go into sleep mode after being idle for a
few minutes. To reset, turn the key off and back on again.
Check List
If your scooter fails to operate, please check the following:
Unit is switched on.
Drive/Freewheel mechanism is in the drive position.
All plugs and connectors are clean and firmly connected. Push reset button.
Battery level shows full charge.
If the free wheel device has been operated with the scooter switched on, then the scooter will not
operate until the ignition key has been switched off and then on again. Please consult
your dealer if your scooter does not run after checking these points.