17
TEMPEST FILTER INSTALLATION
The 1½" pipe clip brackets will clip onto
the connector pipe you have glued into
the inlet and outlet. Locate the pipe clip
brackets between the slide valves and
the filter.
Find a suitable location to install the filter.
You will need to fit a block of wood or
a similar spacer to which the pipe clip
bracket can be screwed. This allows the
filter to stand off from the surface of
the wall.
Use a spirit level to check the filter is
vertical.
Ensure you have enough room underneath
the waste valve assembly to be able to turn
the valve and to connect 1" hose to drain
the water to waste.
Mark the locations and double check them
before fixing.
Use appropriate screws and wall fixings to
fix the pipe clip brackets and the spacer to
your wall.
Once happy the pipe clip brackets are
secure, locate the Tempest filter into the
clips and fit the pipe clip bracket cover.
Your Tempest filter is ready to be connected
up to your pipe work from your filter and
back to your pond using 1½ pressure
pipe work (not supplied). If you prefer to
use 1½" hose you will need to purchase
a Pressure Pipe to Waste Pipe Reducing
Sleeve (EA CODE:
M35-050
) and
1½" Solvent Weld Hosetail
(EA CODE:
HOSETAIL15
).
SPACER
70mm
Approx.
PIPE CLIP
BRACKET