Evolite MOVING BEAM 1R, Руководство пользователя, Страница: 14 / 19

MOVING BEAM 1R Manual Ver. 1.00 Page 14
o
DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.

Set up
o
Control panel
This LCD display indicates the fixture is DMX addressed, the fixture status, set up values ..etc
Main Menu
HOME Set --Run Mode 
DMX/Auto/Sound/Random/ Totem
--DMX Address 
000-512
--Invert Pan 
OFF/ON
--Invert Tilt 
OFF/ON
--Pan-Tilt Swap 
OFF/ON
--Pan-Tilt Encoder 
ON/OFF
--No DMX Signal 
KEEP/CLEAR
--Display 
OFF/ON
--Lamp On@Start up 
OFF/ON
--Load Default (Sure to load default ? Ok /cancel)

Manual mode
N° Function
1 PAN
2 PAN FINE
3 TILT
4 TILT FINE
5 PAN-TILT SPEED
6 SHUTTER/STROBE
7 DIMMER