Evolite HYBRID 10R, Руководство пользователя, Страница: 26 / 28

Hybrid 10R Manual Ver. 1.00 Page 26
248--255 Combination 7
CH15 Prism Index,
Rotation
0--255 Prism index, rotation
CH16 Frost
0--64 No function
65--255 Liner frost
CH17 Zoom In 0—255 Liner zoom in
CH18 Zoom Fine 0--255 Zoom fine
CH19 Focus 0--255 Focus
CH20 Focus zooming 0--255 Focus zooming
CH21 0--255 No function
CH22 Strobe
0--31 Strobe close
32--63 Strobe open
64--95 Strobe from slow to fast
96--127 Strobe open
128--143 Strobe from fast to slow, strobe effects
144--159 Strobe from slow to fast, open slow and
off fast
160--191 Strobe open
192--223
Strobe random, from slow to fast
224--255 Strobe open
CH23 Dimmer 0--255 Liner dimmer
CH24 No function
o
Master/ Slave Mode
The “Master” unit is the unit set up in Auto Mode. The Slave unit will be automatically set up as “Slave” if receiving DMX
signal and NOT “Auto Mode” selected.

Maintenance & service
o
Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s
optics.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days
o
Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and DMX polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the fixture or the previous
one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to
DMX interface circuit.

Some fixtures don’t respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.