Evolite EvoScan 90, Руководство пользователя, Страница: 18 / 19

EvoScan 90 Manual Ver. 1 Page 18

Maintenance & service
o
Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s
optics.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days
o
Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and DMX polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the fixture or the previous
one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to
DMX interface circuit.

Some fixtures don’t respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.

No light out
o
Please check if « shutter » is OPEN ( Channel 6 @ 255)

Technical Specifications
Model EvoScan 90
Voltage 110V- 250V / 50-60Hz
Power consumption: 120W
LED 90 W OSRAM high power white LED
Net Weight / Gross Weight 5.2 / 6.5Kgs
Fixture dimensions 40x36x12cm