Evolite Evo Wash 730z Pix, Руководство пользователя, Страница: 22 / 26

Evo Wash 730z Pix User’s Manual Ver. 1.00 Page
22
is 540°
Select Tilt 270°/90°/180° Tilt Degree,default
is 270°
Mic
sensitivity
Mic SEN 0~99%
MIC Sensitivity
Setting
OFF
Signal
Mode OFF Signal Mode (On/Off)
OFF at original
status and
ON at reset status
when no
DMX signal
MANU
(Manual)
Reset
Total Reset Total Reset
Scan Reset Scan Reset
Zoom Reset
Zoom Reset
Channel
PAN=XXX……
Channel Control
ADV
Advanced
Access
Code 088)
Calibration
PAN=XXX……
Calibration
o
Auto Mode
Press the MENU key then ENTER , then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER , then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
o
DMX Mode
Each device can be individually controlled using a standard DMX-512 controller.
You must "address" each device through the "A001" menu. The filled-in address is then the base
address, address from which the device will respond.
If two devices are addressed to the same DMX address; they will then behave identically, responding
to the same DMX channels.
Wired DMX mode :
Press the MENU key and then DOWN to access the next menu. Then press ENTER then DOWN to reach
the Signal Set menu. Press ENTER and then check the DMX Cable box. Confirm this choice by pressing
ENTER .
Press the MENU key and then UP to go to the first menu. Press ENTER to select the Dmx Address menu.
Use the UP & DOWN keys to select the DMX address of the device. Press ENTER to confirm your choice.
Finally, press MENU 2 times to return to the main menu. The unit is in DMX mode, and if no DMX signal
is present, the display flashes. Then connect a DMX cable as input.
DMX mode selection via W-DMX (wireless):