Evolite Cyclop, Руководство пользователя, Страница: 26 / 27

Cyclop Manual Ver. 1.00 Page
26
o
Master/ Slave Mode
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units.Proper performance it may be necessary to use a terminator at the last fixture. For more information
about terminators.

Maintenance & service
o
Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture’s optics.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days.
o
Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy
troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and DMX
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.