Oxford
®
Oxford Transaid 130
294000.10398 Rev A
4. Overview
The Oxford Transaid 130 consists of the following components:
Seat:
The Transaid is equipped with a black plastic seat. To install the seat, pull the two seat support tubes out fully
and place the seat (with grooves facing downwards) on top of the seat support tubes. The carry handle slot
should be on the outside edge.
Footplate:
The footplate is equipped with a non-slip layer to prevent the patient’s feet from moving during the standing
and transfer process.
Back support:
The Transaid has a detachable back support (inside width 49.5cm). It is designed to provide reassurance for the
patient during the transfer and encourage them to sit in an upright position. The back support should always be
in the transfer position when transferring the patient.
Castors:
The Oxford Transaid has six castors. Four castors on the front of the device and two larger braked castors positioned
at the rear. To prevent the Oxford Transaid from moving unintentionally, apply the brake on the rear castors.
6
Fig. 1
1. Seat
. Footplate
. Back support
. Locking castor
. Front castor
. Front grab rail
7. Seat support tubes
8. Seat storage area and retaining clips
9. Seat Pad (Sold separately)
8
7
5
4
3
2
1
9
