Assembly and Maintenance
- 18 -
IPC-820
IO port of the motherboard);
2. According to the number of mounting holes of the motherboard, use same number
of copper hexagon screws CH-M3-8-5-Ni and lock them on the self-clinching bolts of
the chassis;
3. Place the motherboard to be installed on the copper bolts, gently align the position
of IO port and mounting holes, and use proper number of M3*8 screws with washers
to fasten the motherboard;
4. Put the binding strip on the installation position of the chassis, and use cup head
M4*6 screws with external teeth lock washers to fasten it.
Removing ATX motherboard:
1. Loosen the countersunk head screws on the chassis cover, then remove the cover;
2. Loosen the cup head M4*6 screws with external teeth lock washers to remove the
binding strip;
3. Loosen the M3*8 screws with washers fixing the motherboard, then the
motherboard can be taken out from the chassis.
6.2.2 Installation and Removal of EPE Motherboard
Содержание IPC-820
