13
7. Assemble leg to the burner unit using philips screw (40),
and nyloc hex nut (41).
8.
Use 7/16” open-end wrench and phillips screwdriver
tools to fasten the legs to burner unit.
Securely tighten screws by holding screwdriver
steady against the screw head while using the
wrench to tighten nut.
9.
Repeat for each leg mounting location.
Assembling Your Evo Grill
1.
Stand completed leg assembly in an upright position with
the control panel facing forward.
2.
Place burner unit over leg assembly with control panel
centered between front legs with right and left wheels on
each side.
3.
Gently lower skirt onto leg assembly making sure the up-
per tab of each leg rests outside the burner unit skirt.
4.
Allow the skirt to gently slide into the vertically angled
mounting channels of each leg.
5.
Make sure the mounting hole on the skirt is positioned
inside the tab of each leg.
It will be necessary to engage burner unit skirt to leg
assembly by using a hammer against a small block of
wood and lightly tapping the skirt into the channel of
each leg tab.
The leg tab will slide over the exposed rivet head
located below the fi rst mounting hole of each leg.
When the leg tab is properly installed, the rivet head
will be under the tab and no longer in view.
6.
Position the burner unit skirt so the mounting hole in each
leg tab is visually aligned outside the mounting hole of
the skirt.
Leg Assembly To Burner Unit
Burner Unit Skirt goes to
inside of Leg Tab on all
three legs
Skirt slides into leg chan-
nel on all three legs
Some parts may contain sharp edges.
Wear protective gloves as necessary.
