TO OPERATE WITH A BATTERY POWERED CONTROLLER
1. Turn the Battery Powered Controller
upside down. Slide the battery cover
in the direction of the arrow to
remove the lid. Put in three (3) "AA"
disposable alkaline or lithium batteries,
matching them to the plus (+) and
minus (-) markings inside the Battery
Powered Controller. Replace the cover
on the Battery Powered Controller and
slide the cover until it locks in place.
You can expect at least three (3) hours
of operation from a new set of
disposable batteries, (up to five (5)
hours from high performance batteries).
2. Insert the nebulizer cable connector
into the back of the Nebulizer Unit.
Slide the cable straight up the
nebulizer body.
3. Connect the nebulizer cable to the
Aeroneb
®
Go Battery Powered
Controller.
4. Turn on the unit by pressing the "on/off"
button on the Battery Powered
Controller.The green light on the Battery
Powered Controller will light up. Visually
verify that aerosol is coming out of the
mouthpiece or mask to indicate that the
device is functioning properly.
NOTE: (1)
If you are using batteries and the green light is flash-
ing, your batteries are low. You may finish your treatment, and
7
12
DAILY: (Cont.)
1. Wash the Nebulizer Unit (Medication Cup and Cap, Nebulizer
Body, and Mouthpiece or Mask Adapter and Mask) by hand
in a solution of warm water and mild liquid dishwashing
soap. Use soap intended only for washing dishes by hand.
Do not use dishwasher detergent as it is too abrasive. Do not
leave parts soaking in soapy water for more than 20 minutes.
2. Rinse all pieces thoroughly under running hot tap water.
Make sure that no soap is left on any of the parts.
3. Shake off excess water and allow parts to air dry on a clean,
dry towel, out of the reach of children.
4. Make certain that all cleaned parts are completely dry before
you store or use them. Do NOT remove the retaining ring
under the medication cup.
NOTE:
If the Medication Cup is not properly cleaned after every
use the nebulizer may become clogged with medication.
Improper cleaning will result in poor performance and increased
time to nebulize the medication.
NOTE:
Water remaining on the underside of the Aeroneb
®
Go
generator after cleaning may cause the unit not to work. Be sure
the unit is completely dry prior to use.
NOTE:
Do NOT clean the nebulizer in a dishwasher.
OPTIONAL DISINFECTION:
If you would like to disinfect your Aeroneb
®
Go Nebulizer, you
may use the following method.
VINEGAR SOLUTION:
I. First, clean the Nebulizer Unit as described in the daily
cleaning section, following steps 1- 2.
II. Fill a container with a mixture of three (3) cups hot water to
one (1) cup white distilled vinegar.
(example: Heinz Distilled White Vinegar)
