2
Installation Instructions
Customer Assistance
For more info
For technical questions regarding the installation or operation
of this product, please contact our customer support team:
www.ambientechinc.com
347-334-6368 ext 3
Caution
To reduce the risk of overheating and possible damage to
other equipment, do not install to control a receptacle,
A motor-operated appliance, or a transformer-supplied
appliance.
"GRADATEURS COMMANDANT UN BALLAST - AFIN DE
REDUIRE LE RISQUE DE SURCHAUFFE ET LA POSSIBILITE
D'ENDOMMAGEMENT A D'AUTRES MATERIELS, NE PAS
INSTALLER POUR COMMANDER UNE PRISE, UN APPAREIL A
MOTEUR,"
FCC/IC Information
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1
.
This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Troubleshooting
Wall Switch LED
Indicator blinking
RED
The pairing / reset
button is pressed
while the wall switch
is off
Turn ON the Wall Switch
and press the Pairing
button again
Wall Switch
LED Indicator
steady RED
The Wall Switch is
trying to perform
pairing
Turn ON the
Wall Switch until
paring is completed
Lights do not
respond to
Wall Switch
The Breaker is Off
or tripped
Turn power ON at
the Circuit breaker
Improper pairing
Perform “Pairing”
Improper wiring
Make sure all wires
are connected
according to the
wiring diagram
Short circuit at
the LED Driver
output
Check LED Driver
output for short
circuits
Symptoms
Cause
Possible Solution
The wall switch is
controlling
the wrong lights
(Only if multiple
Wall Switches units are
installed in the
same location)
The Wall Switch was
paired with the
wrong LED Driver
Perform “Pairing”.
Make sure all the other
Wall Switches are turned
Off while pairing
Wall Switch / LED Driver
Replacement
Any reason
Perform “Pairing”.
Make sure all the other
Wall Switches are
turned Off while
pairing
EVO-LITE, LLC. � ARVADA, COLORADO
WWW.EVO-LITE.COM � [email protected] � 888-887-2980 � V3922