1
Installation Instructions
Smart Wall Switch Installation
1.
Make sure that the ends of the wires from the wall box
are straight (cut if needed).
2.
Strip the wire insulator for each wire
inside the wall box as shown here:
Strip the wire insulation from each wire.
Strip 5/8”(1.6 cm)
Wall Box
1.
A standard single-gang wall box sized 3 x 2 x 2 ½ cm will service Dimmer
2.
Not compatible with multi or double Mud Rings.
3.
When using a retrofit gang box (cut in box) you might need
to recess the ears.
Wiring Option 1
Electrical Connection
Red
Green
Ground
Black
Neutral
White
Line / Hot
120 V~
50/60 Hz
Wall Switch
(In-Wall Dimmer)
LED Driver
(Load)
LED Indicator
LED Indicator
Wiring Option 2
Stand-alone Wall Switch
Before You Begin
To avoid fire, shock, or death, turn the
power Off at circuit breaker and test to
ensure the power is Off before wiring.
ON
OFF
P/N:TONE-WSx-SA-EVO
WARM-WSx-SA-EVO
TECH-WSx-SA-EVO
Red
Green
Ground
Black
Neutral
White
Pair Button
Line / Hot
120 V~
50/60 Hz
Wall Switch
(In-Wall Dimmer)
LED Driver
(Load)
Pair /
Reset
Button
Pair /
Reset
Button
Provided by
www.evo-lite.com
1. Make sure all sliders are set to the top and the Wall Switch
is in the OFF position.
2. Turn the power ON at the circuit breaker.
3. Press the Pair button on all drivers that will be synced to
this Wall Switch.
Please Note: You have 5 minutes from the moment the
first driver’s button is pressed to complete the sync to the
wall switch before the signal times out.
4. Turn ON the Wall Switch and press the Pair / Reset button
on the Wall Switch.
5. The green LED indicator will blink while pairing.
6. Within 15 seconds your LED fixture will be paired with the
Wall Switch.
7. To verify that pairing was successful, move the sliders and
ensure that the connected lighting product responds
accordingly.
1. Make sure all sliders are set to the top and the Wall Switch
is in the OFF position.
2. Switch the power ON at the circuit breaker.
3. Turn ON the Wall Switch and press its Pair / Reset button.
The green LED indicator will blink while pairing.
4. The pairing process will be completed within 15 seconds.
5. To verify that pairing was successful, move the sliders and
ensure that the connected lighting product responds
accordingly.
6. If the Wall Switch is not functioning correctly, set all Wall
Switch sliders to the top, turn ON the Wall Switch, then
press its Pair / Reset button. The connection will be
refreshed and corrected within 15 seconds.
If you are installing more than one Wall Switch unit, all
others must be switched OFF while pairing.*
If you are installing more than one Wall Switch unit, all
others must be switched OFF while pairing.*
If pairing is unsuccessful, please repeat the pairing process.
Factory Reset
Resetting products is not required. Once the Pair / Reset button is pressed it
will override any previous sync settings.
*Please note: 3-way multiswitch operation is currently unavailable.
Download the SmartAir App
Scan the QR code to download the smart device
app. Follow the instructions to connect your lights
to the SmartAir App.
EVO-LITE, LLC. � ARVADA, COLORADO
WWW.EVO-LITE.COM � [email protected] � 888-887-2980 � V3922
