EVINRUDE
115 – 300 HP
EMM
SERVICE CODE CHART
CODE
EMM
CIRCUIT/SENSOR
INTERNAL
SE
NS
OR
S.A.F
.E
SHUT
DOWN
EMM
LED DISPLAY
DASHBOARD
GAUGE WARNING
DISPLAY
TIME TO
ACTIVATE
SENSOR: CIRCUIT VOLTAGE / RESISTANCE (
Ω
) / INFORMATION
1-6 Excessive knock detected
3
-
CHECK ENGINE
Immediate
Code number indicates affected cylinder. 20 knock events in 100 combustion cycles with maximum correction applied.
Make sure sensor is securely fastened to the cylinder head.
Check timing adjustments. Test fuel and cooling systems. Check fuel quality.
7-8 Knock Sensor circuit OPEN – Port/Stbd
LED 3: OFF (Cranking) / ON (Running)
CHECK ENGINE
5 seconds
Sensor output < 0.15 V and RPM > 3000. Check sensor connection.
11
Throttle Position Sensor
(TPS) out of idle range
-
-
2 seconds
TPS Voltage > 0.65 V with key ON (or cranking). Becomes stored fault when outboard starts.
When both hard and stored faults are present, check for improperly adjusted throttle cable.
If voltage is > .78 V, engine speed is limited to idle.
12
Throttle Position Sensor
(TPS) circuit fault
LED 3: OFF (Cranking) / ON (Running)
CHECK ENGINE
2 seconds
TPS Voltage: < 0.14 V, or > 4.92 V. Engine limited to idle speed.
Check sensor resistance—3000
Ω
(between pins A and B
) &
4000
Ω
(between pins A and C
)
13 TPS below range
LED 3: OFF (Cranking) / ON (Running)
CHECK ENGINE
10 seconds
TPS Voltage < 0.2 V. Check linkage and IDLE stop.
14 TPS above range
LED 3: OFF (Cranking) / ON (Running)
CHECK ENGINE
10 seconds
TPS Voltage > 4.85 V. Check linkage and WOT stop.
15 ROM (
EMM
program)
3
-
-
15 seconds
ROM “CHECKSUM” failure. Check software program number in
EMM
. Reload or replace with proper program.
16
Crankshaft Position Sensor (CPS)
Intermittent loss of SYNC
LED 2: OFF (Cranking)
LED 3: ON (Running)
-
5 losses, rpm<2000
1 loss, rpm >2000
EMM
counts losses of synchronization with crankshaft sensor. Check CPS mounting and resistance. Air gap range: 00.036 to
0.110 in. (1 to 2.8 mm), nominal 0.073 in. (1.85 mm) Resistance: 560
Ω
± 10% @ 77°F (25°C)
17 55 V circuit BELOW range
3 3
LED 1: ON (Running)
CHECK ENGINE
1 min: V4–3.3L V6
10 sec: 3.4L V6
55 V alternator output < 45 V at 500 to 1000 RPM, or < 52 V above 1000 RPM.
Engine limited to 1200 RPM. Perform stator/charging tests.
18 55 V circuit ABOVE range
3 3
LED 1: ON (Running)
CHECK ENGINE
1 minute
System Voltage > 57 V. Engine limited to 1200 RPM. Perform stator/charging tests.
Check for loose connections in 55 V circuit. Check capacitor.
19 Start-in-gear
LED 3: OFF (Cranking)
CHECK ENGINE
-
Attempted engine start while in gear (
EMM
in tiller mode). Engine will not start.
21 Winterization activated
All LEDs FLASHING
All LEDs FLASHING
-
Engine is speed limited, and stops after 360 oil pulses. Refer to Maintenance or Operator’s Guide.
23
EMM
Temperature Sensor circuit fault
3
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
EMM
Temperature < -67° F (-55° C), or > 311° F (155° C).
24
EMM
Temperature BELOW range
3
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
EMM
Temperature < -22 ° F (-30° C).
25
EMM
Temperature ABOVE range
3 3
LED 4: ON (Running)
WATER TEMP/HOT
10 seconds
EMM
Temperature > 176°F (80°C). Engine limited to 1200 RPM. See Code 29.
26 12 V circuit BELOW range
3
LED 1: ON (Running)
LOW BATTERY
5 minutes
Battery voltage <12 V below 2000 RPM or < 12.5 V above 2000 RPM. Perform stator/charging tests.
27 12 V circuit ABOVE range
3
LED 1: ON (Running)
LOW BATTERY
5 minutes
Battery voltage > 15.5 V. Check battery connections and wiring.
28 Shift switch malfunction
LED 3: ON (Running)
-
10 seconds
Check shift switch linkage and switch activation. Check continuity of switch: normally open / continuity depressed.
90°V6 models only.
29
EMM
Temperature OVER range
3
3
LED 4: FLASHING
WATER TEMP/HOT
(FLASHING)
5 seconds
EMM
Temperature > 212° F (100° C). Engine SHUTDOWN. Will NOT restart until
EMM
temperature
returns to operating range. Check outboard and
EMM
cooling systems.
31 Engine temperature OVER range
3
LED 4: FLASHING
WATER TEMP/HOT
(FLASHING)
3 seconds
Engine Temperature > 248° F (120° C). Engine SHUTDOWN. Check cooling system.
Check temperature sensor resistance—9000 to 11000
Ω
@ 77°F (25°C).
33 Critical NO OIL detected
3
3
LED 4: FLASHING
NO OIL (FLASHING)
5 hours
Outboard has run five hours with code 34 or 38. Engine SHUTDOWN. Will restart and run for 1 minute intervals.
34 Oil injection pump circuit OPEN
3
LED 4: ON (Running)
NO OIL
4 seconds
Engine limited to 1200 RPM. Check oil injection pump circuit resistance—2-3
Ω.
36 Rear Oil injection pump circuit OPEN (3.4 L)
3
LED 4: ON (Running)
NO OIL
4 seconds
Engine limited to 1200 RPM. Check oil injection pump circuit resistance—5-6
Ω.
37 Water in fuel
LED 3: OFF (Cranking) / ON (Running)
CHECK ENGINE
10 seconds
Check fuel supply, 5 V circuit, and ground (NEG). Resistance between probes should be infinite (no continuity).
38 Oil pressure feedback NOT detected
3
LED 4: ON (Running)
NO OIL
60° V4 100 oiler cycles
60° V6 150 oiler cycles
90° V6
(3.3L)
150 oiler cycles
90° V6
(3.4L)
75 oiler cycles
Loss of oil manifold pressure. Engine limited to 1200 RPM. Check oil supply.
Test injection pump. Monitor oil flow to distribution hoses.
40
Engine Temperature ABOVE range (port)–
low speed
3
LED 4: ON (Running)
WATER TEMP/HOT
3 seconds
60° V4 & V6 Models: Engine Temperature > 230° F (110° C) below 3000 RPM
90° V6 Models: Engine Temperature > 230° F (110° C) below 2000 RPM
41
Engine Temperature Sensor circuit fault
(port)
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
Engine Temperature < -13° F (-25° C), or > 329° F (165° C).
Check 5 V circuit and ground (NEG), and sensor resistance—9000 to 11000
Ω
@ 77°F (25°C).
42 Engine Temperature BELOW range (port)
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
Engine Temperature < -4° F (-20° C). Check engine temperature and sensor resistance.
43 Engine Temperature ABOVE range (port)
3
LED 4: ON (Running)
WATER TEMP/HOT
3 seconds
60° V4 & V6 Models: Engine Temperature
>
194°F (90°C) above 3000 RPM activates S.A.F.E.
90° V6 Models: Engine Temperature > 185° F (85° C) above 2000 RPM for 60 seconds activates warning light and horn;
90° V6 Models: Engine Temperature
>
194°F (90°C) above 2000 RPM for 3 seconds activates S.A.F.E.
Engine limited to 1200 RPM. Check cooling system.
44
Barometric Pressure (BP) Sensor circuit
fault
3
-
-
10 seconds
Pressure < 3.8 in. Hg (13 kPa), or > 35.1 in. Hg (119.0 kPa). Make sure
EMM
BP sensor tube is NOT plugged.
Check atmospheric condition for comparison. Clear code and retest.
45 BP Sensor BELOW range
3
-
-
10 seconds
Pressure < 20.7 in. Hg (70 kPa).
46 BP Sensor ABOVE range
3
-
-
10 seconds
Pressure > 31 in. Hg (105 kPa).
47 Air Temperature (AT) circuit fault
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
Air temperature < -67° F (-55° C), or > 212° F (100° C).
Check 5 V circuit and ground (NEG), and sensor resistance—9000 to 11000
Ω
@ 77°F (25°C).
48 Air Temperature BELOW range
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
Air temperature below -22°F (-30°C)
49 Air Temperature ABOVE range
LED 3: OFF (Cranking) / ON (Running)
-
10 seconds
Air temperature above 158°F (70°C)
Содержание E-TEC 200
