Evinrude B10EL4, Руководство оператора

Страница: 39 / 92

39
ENGINE OPERATION
6
E and P type
①
Put the shift lever in the Neutral
position and run the engine for 2-3
minutes at idling speed if it has
been running at full speed.
②
Turn the main switch key to the
OFF position.
Notes
●
After stopping the engine, close the
air vent screw on the tank cap.
●
Disconnect the fuel connector of
the engine or the fuel tank.
●
Disconnect the battery cord of the
TE, E, TP or P type engine, if the
engine will not be used for more than
3 days.
(N)
Stop switch lock
OFF
ON
START
The trim angle of the outboard motor
can be adjusted to suit the transom
angle of the hull, and load conditions.
Choose an appropriate trim angle
that will allow the anti-ventilation plate
to run parallel to the water surface
during operation.
■
Proper trim angle
The position of the thrust rod (or
preset knob) is correct if the hull is
horizontal during operation.
■
Improper trim angle
Set the thrust rod (or preset knob)
lower if the bow of the boat rises
above horizontal.
Remark) Thrust rod is for R and TE,
and preset knob is for E.
7. Trim angle
Perpendicular to the
water surface
Set the thrast rod lower
OM_E_10HP_body_111213.indd 39 11/12/13 13:23