Evil Pimp Kit, Руководство оператора

Страница: 11 / 17

17
UNLOCKING BOLT REMOVING BOLT RE-INSTALLING BOLT
Twist the back of the bolt 180º
in either direction. Pull out
Line up with the back of marker so a
sliver of the white bolt is showing &
twist bolt 180º to lock back in place.
MAKE SURE BOLT LOCKS IN PLACE IN HAMMER. DO NOT CYCLE MARKER
WITHOUT BOLT PROPERLY LOCKED IN PLACE.
The EVIL ® Pimp Kit ™ stock delrin bolt needs no maintenance. Always clean marker after
every day of play. This usually does not mean a complete strip. On the contrary, most
warranty calls originate from improper assembly by the operator. However, do not
hesitate to call Evil HQ with questions.
Bolt Position Screw Adjustment
Pimp Kit ™ Ram assemblies have a Ram Piston adjustment screw (69) in the back. If the
top of the bolt is visible when looking down the
feed tube while the marker is aired up, then that
screw is too far forward. If the ball is rolling
backwards off the eye once it is in the chamber,
then that screw is too far back. Do not attempt to
adjust unless one of these two problems is causing
the Pimp Kit
™ to break paint.
Use a 1/8 allen wrench to adjust the Ram Piston
screw. Make sure to use a drop of Red 277 Loc Tite
on the center of the screw while it is removed from the Ram so the screw won’t move
after adjustment is made. Allow to dry for 24 hours before cycling marker.
Do not leave marker in direct sunlight. In extreme circumstances it can cause the bolt
to swell.
Remove these two screws with
a 5/64 allen wrench
Replace worn or damaged ball detents
The eyes can be gently removed and cleaned by
factory trained technicians only. Broken or pinched
wires are not covered under the warranty.
If the electronic eyes get paint or dirt on them, they will not
function properly.
The ball detents will wear over time and will have to be replaced. Check ball detents
if the Pimp Kit
™ is chopping or breaking paint.
DO NOT PUSH BOLT TOO FAR FORWARD IN PIMP KIT ™ OR YOU WILL DAMAGE
BALL DETENTS.
Changing the Battery
The 9 Volt battery will need to be occasionally replaced as part of normal
maintenance. You should get over 50,000 shots before the battery needs to be
replaced. When troubleshooting the marker, always check or replace battery.
1
Remove the 2 grip cheek screws on the left hand side of the
marker with a 5/64 allen wrench.
2
Remove the 4 panel screws with a 5/64 allen wrench.
See picture for screw locations.
3
Remove the bottomline adapter and rail if the panel does
not remove easily
4
Carefully replace battery with a fresh 9 Volt.
EVIL ® Pimp Kit ™ Eye & Ball Detent Replacement EVIL ® Pimp Kit ™ Bolt Removal
Good
Damaged
16