As you insert the screws, tighten them with
the ball end of the 5/64” hex wrench.
Be careful not to over-tighten the screws.
And, tighten the screws on both sides.
The other four screws go into the standoffs from the
other side, again through the holes with solid outlines.
STEP 9: Mating the two tailstock pieces
[Egg-Bot Kit Assembly Guide]
Test
fi
t the two tailstock pieces together: the standoffs
go against the holes with the dashed outlines.
When you’re done, the tailstock should
look like this. You should have a clear
view through both nylon bushings.
