MViP User's Guide
Page - 2
Revision 1.1
PKG-MViP-IP
MViP
PKG-MViP-TSM-IP
7780TSM-IP
7800 Frame-based
Transport Stream Monitor
DVI-D 1 (Digital Only)
DVI-D 2 (Digital Only)
Ethernet Data
Ethernet Control
Control
/SNMP Network
Broadcast
Network
Ethernet Data
Ethernet Control
Ethernet Data
Ethernet Control
MViP
DVI-D 1 (Digital Only)
DVI-D 2 (Digital Only)
Control
/SNMP Network
Broadcast
Network
Figure 1-2: MViP Block Diagram
1.1.
GETTING STARTED: SETTING UP THE MVIP HARDWARE
In order to set up the MViP hardware, please follow the instructions outlined below:
1. Remove the MViP 2RU frame from the shipping container. Please note: The unit is heavy; therefore, it
is recommended that two people remove the unit from the container.
2. Remove the side rails from the shipping container. If the MViP is to be rack mounted, the side rails
must be securely fastened to the MViP before mounting the unit in a 19” equipment rack.
3. Attach the side rails to the chassis. Please refer to the documentation that comes with the side rails for
further instructions on installation.
4. To securely fasten the MViP to the equipment rack, make sure that the mounting screws are tightened
securely. Please note: The unit is heavy; therefore, it is recommended that two people fasten the unit
to the rack. If the user is not rack mounting the MViP, please proceed to step 5.
