CP-1024E
Control Panel
2. INSTALLATION
2.1. REAR
PANEL
Figure 2-1 shows the rear view of the CP-1024E control panel. The CP-1024E is a 1RU panel with
various connection ports. Sections 2.1.1 to 2.1.5 describe the function of the connectors on the rear
panel.
Figure 2-1: CP-1024E Rear Panel
2.1.1. Serial
Connections
SERIAL A, B, C:
Port A is a female 9 pin D connector that is used as the RS-232 upgrade port. Ports
B and C are 9 pin D connectors that provide RS-422 and RS-232 serial interface
connection.
2.1.2. Setup Rotary Encoder and Four Digit Display
SETUP:
Not used (Setup configuration is done from the front of the panel)
LED Display:
This 4 digit LED display identifies the model number of the unit. (ie.1024).
2.1.3. Joystick
This male DB9 connector is used for connection to a camera control unit to allow the joystick push
buttons to override the router.
2.1.4. USB
Control
This USB 2.0 Port is used for USB-based firmware upgrades of the CP-1024E.
2.1.5. Ethernet
Connection
The cards use 10Base-T (10 Mbps), 100Base-TX (100 Mbps) twisted pair Ethernet cabling systems.
When connecting for
10Base-T systems, category 3, 4, or 5 UTP cable as well as EIA/TIA – 568 100
Ω
STP cable may be used. When connecting for 100Base-TX systems, category 5 UTP cable is required.
The cable must be “straight-through” with an RJ-45 connector at each end. Establish the network
connection by plugging one end of the cable into the RJ-45 receptacle of the card and the other end
into a port of the supporting hub.
The straight-through RJ-45 cable can be purchased or can be constructed using the pin-out
information in Table 2-1. A colour coded wiring table is provided in Table 2-1 for the current RJ-45
standards (AT&T 258A or EIA/TIA 258B colour coding shown). Also refer to the notes following the
table for additional wiring guide information.
Page 2
Revision 1.1
