9780MUX-IPGE-ASI
Compact ASI/IP Re/De-Multiplexer
Page - 4
Revision 1.0
2.2.
CONFIGURING THE CONTROL PORT
2.2.1. Configuring control port from the Front panel
Connecting the device to the computer:
Table
2-1 illustrates the different drop down menus for setting up the network configurations.
Scroll between the menus by using the up and down arrow buttons and pressing Select to
choose items or Esc to exit one back.
Main Button
Sub Menus
System
Network
Control
Netmask, IP Address, Gateway, DHCP
Data Main
Netmask, IP Address, Gateway, DHCP
Data Backup
Netmask, IP Address, Gateway, DHCP
Apply
Changes
Netmask, IP Address, Gateway, DHCP
Table
2-1 : Front Panel of 9780MUX for Network Configuration
1. To check the IP address of the device, select the
System
button on the front panel of the
encoder and scroll down to Control and press Select button. Scroll down to IP address and
press select button. The IP address of the 9780MUX will be displayed.
2. Press “
ESC
” if no changes are required or “
Select
” to make changes to each octet of the IP
address.
3. Once completed, navigate to the
Network
submenu and select
Apply
changes.
4. In the
Control
submenu, select
Reboot System
to make sure new settings are applied.
5. Plug in a standard Ethernet cable (CAT-5E) from PC’s Ethernet network to the control port of
the device.
6. On the computer screen, select “Start” in the bottom left corner. Then select “Control Panel”.
Search for “Network Connections” icon and double click it. Double click the interface icon “Local
area connection” and click the “properties” button. Following that, select “Internet Protocol
(TCP/IP4)” and click the “properties” button again. Select the button labelled “Use the following
IP address” and click OK.
7. Verify that the computer is on the same control/management subnet as the 9780MUX. For
example, if the 9780MUX’s control/management IP address is 192.168.77.100, set the PC to
192.168.77.xxx where xxx is user’s choice.
8. Now check communication with the device. Select “Start” in the bottom left corner of the
computer screen. Then select “Run…” and in the space provided enter “cmd” followed by
clicking the “Enter” button. In the command prompt, type “ipconfig” and push the “Enter” key.
This will confirm that the IP address has been set. Type “ping” followed by the IP address and
press the Enter key again, if the IP address replies as is shown in Figure
2-2, then it is
connected.
Содержание 9780MUX-IPGE-ASI
Страница 2: ...This page left intentionally blank ...
Страница 10: ...9780MUX IPGE ASI Compact ASI IP Re De Multiplexer Page vi Revision 1 0 This page left intentionally blank ...
Страница 58: ...9780MUX IPGE ASI Compact ASI IP Re De Multiplexer Page 48 Revision 1 0 This page left intentionally blank ...
Страница 64: ...9780MUX IPGE ASI Compact ASI IP Re De Multiplexer Page 54 Revision 1 0 This page left intentionally blank ...