evertz 7700ACO-HD, Руководство пользователя

Страница: 25 / 40

7700 MultiFrame Manual
7700ACO-HD HD/SD SDI 8 Channel AES & RS-232/RS-422 Auto Changeover
Revision 1.3
Page 13
6. CARD EDGE MENU SYSTEM
6.1. NAVIGATING THE MENU SYSTEM
You can use the toggle switch to move up and down the list of available parameters. To adjust any
parameter, use the toggle switch to move up or down to the desired parameter and press the pushbutton.
Using the toggle switch, adjust the parameter to its desired value. If the parameter is a numerical value,
the number will increase if you lift the toggle switch and decrease if you push down on the toggle switch.
If the parameter contains a list of choices, you can cycle through the list by pressing the toggle switch in
either direction. The parameter values are changed as you cycle through the list.
When you have stopped at the desired value, depress the pushbutton. This will return you to the
parameter select menu item you are setting (the display shows the parameter name you were setting). To
change another parameter, use the toggle switch to select other parameters. If neither the toggle switch
nor pushbutton is operated for approximately 30 seconds, the card edge control will exit the menu system
and return to an idle state.
6.2. CARD EDGE STATUS MESSAGES
There are four messages that may appear on the card edge display during normal operation (monitor
mode) of the module. The messages are:
SW A
Indicates Bank A is active.
SW B
Indicates Bank B is active.
Table 6-1: Card Edge Status Messages (Monitor mode is BANK)
SDIA
Displays the type of signal present at HD/SD Input A.
SDIB
Displays the type of signal present at HD/SD Input B.
AESA
Displays which AES inputs are present at AES Input A.
AESB
Displays which AES inputs are present at AES Input B.
Table 6-2: Card Edge Status Messages (Monitor mode is FULL)