TSC06-C Gateway User Manual
Page 3 of 25
RJ-45 Socket:
There are two RJ-45 sockets. TSC06-C has the Ethernet hub function.
These two sockets are linked. In SFR, one will connect to SFR modem;
another will connect to SFR mini hub.
5.2.
Buttons
There are two buttons on TSC06-C: one is the reset button (near the dummy
USB socket), and another is the connection button (near the RJ-45 socket).
Reset Button:
This button will reboot the system. If the system is halting, the user can
press this button.
Note:
TSC06-C has a battery inside its body. If the DC power is cut off, the
unit will automatically switch to the battery power. As a result, the device
would be still halting and need to be reset.
Connection Button:
Enable the firmware upgrade function in boot time.
After pressing the reset button or powering on the device, press the
connection button for more than three times. To ensure the function is
enabled, please check the connection LED is blinking in red and green.
Set all settings of the device to factory default.
After pressing the reset button or powering on the device, press and
hold the connection button until the connection LED turns on the red
and green light and then turns off. Then release the connection
button.
Manually enable the bind function.
After the system boots up, press the connection button once.
Manually cancel the bind function.
When the system is in the binding mode, press the connection button
once.
