2
4. Prepare one 9V alkaline battery. Do not insert it into the unit yet.
5. Log into the Homesys account from a web browser.
6. Select “System”, then “Add a Device”,
7. Select “Smoke Detector”.
8. The following screen will appear. This means the gateway is entering binding
mode.
9. Insert the batteries with correct polarity at this point.
10. Plug the connector
back to connector pins
of the sensor module. Make
sure its direction is correctly inserted according to the sticker affixed on the
sensor.
11. The screen below will appear in 10 seconds if the process is successful.
12. Time-out will occur if the binding process was unsuccessful. Please refer to
the “Manual Binding” procedure.
Manual Binding
1. Repeat steps 4 to 8 of the Binding with Homesys section.
2. With the battery inserted and connector
connected to sensor module,
press and hold the Learning key
for 3 seconds then release, and the Link
LED
○
10
will start to flash. This implies SF804-0 has now entered binding
mode.
3. Within 5 seconds, the Link LED will stop flashing and then turn off, indicating
