background image

For sales, replacement components, and service, contact your Everpure dealer or:

Everpure, LLC: 

1040 Muirfield Drive • Hanover Park, Illinois 60133 • 800.323.7873

In Europe: 

Toekomstlaan 30 • B-2200 Herentals, Belguim

In Japan: 

Hashimoto MN Bldg. 7F • 3-25-1 Hashimoto Sagamihara-Shi • Kanagawa 229-1103, Japan

Printed in U.S.A. 

EV3100-91C   FE05

Technical Service

800.942.1153

www.everpure.com

12.   Pour a capful of bleach into the tubing connected in step 11 onto the 3/4” NPT x 3/4” barb connector at the surge tank ball valve and then 

immediately connect the loose tubing end to the 1/2” NPT x 3/4” barb connector installed in step 7.  Fully tighten the remaining tubing clamp 

to secure the tubing onto the connector barb.

13.   Place the high flow filter system into service by opening the inlet water ball valve. Open the surge tank ball valve and allow the surge tank to 

fill for three minutes.

14.   Connect a hose to the high flow filter system activation valve connected to the plated cross. Close inlet valve to the highflow system. Open 

the flush valve and allow the water to drain to waste for five minutes in order to expel chlorinated water from the surge tank or until no 

chlorine odor is detected. Then close the flush valve and open the inlet valve to the high flow system. If new cartridges installed, flush high 

flow system for five minutes. The high flow filter system and surge tank is now in service. 

15.  Inspect the system for any water leakage, tightening all connections as required until no leakage is observed.

16.   After installation of the surge tank, it will be necessary to close the surge tank ball valve prior to removing cartridges from the pre-filter or 

high flow filter system. 

Before removing any filter cartridges always close the ball valve on the surge tank.

SERVICE

No routine servicing of the surge tank is required under normal operating conditions although periodic sanitizing (annual) is recommended. The 

only servicing of the surge tank occurs if the internal air bladder pressure (excluding water pressure) is not 20±2 psi when empty. A conventional 

tire valve is provided at the top of the extra capacity surge tank and near the bottom of the standard surge tank to monitor and adjust the internal 

pressure.

LIMITED WARRANTY

COMMERCIAL WATER TREATMENT EQUIPMENT

You have just purchased one of the finest water treatment units made. As an expression of our confidence in Everpure products, this product is warranted 

against defects in material and workmanship to the original end-user when installed in accordance with Everpure specifications. The warranty period 

commences from the date of purchase and is administered as follows:

 

For a period of ONE YEAR 

Replaceable elements (i.e., filter & water treatment cartridges)*

 

For a period of FIVE YEARS 

The entire system (excluding replaceable elements)

 

*This is for material & workmanship, not filter or water treatment cartridge life.

The unit must be used in operating conditions that conform to Everpure’s recommended design guidelines. This warranty will not apply if the unit has been 

modified, repaired or altered by someone not authorized by Everpure. 

If a part described above is found defective within the specified period, you should notify Everpure technical service at the phone number listed below. 

Any part found defective within the terms of this warranty will be repaired or replaced (at Everpure’s discretion) by your local dealer or Everpure technical 

service. You pay only freight from our factory and local dealer charges. Any repaired or replaced warranty item will be incorporated under the original 

warranty terms of the existing system.

We are not responsible for damage caused by accident, fire, flood, freezing, Act of God, misuse, misapplication, neglect, oxidizing agents (such as chlorine, 

ozone, chloramines and other related components), alteration, installation or operation contrary to our printed instructions, or by the use of accessories or 

components which do not meet Everpure’s specifications. Refer to the specifications section in the Installation and Operating manual for approved application 

parameters.
Our product performance specifications are furnished with each water treatment unit. TO THE EXTENT PERMITTED BY LAW, EVERPURE DISCLAIMS ALL 

IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE; TO THE EXTENT 

REQUIRED BY LAW, ANY SUCH IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE PERIOD SPECIFIED ABOVE FOR THE ENTIRE WATER TREATMENT 

UNIT. As a manufacturer, we do not know the characteristics of your water supply or the purpose for which you are purchasing this product. The quality of 

water supplies may vary seasonally or over a period of time, and your water usage rate may vary as well. Water characteristics can also differ considerably 

if this product is moved to a new location. For these reasons, we assume no liability for the determination of the proper equipment necessary to meet your 

requirements, and we do not authorize others to assume such obligations for us. Further, we assume no liability and extend no warranties, express or implied, 

for the use of this product with a non-potable water source or a water source which does not meet the conditions for use described in the owner’s guide or 

performance data sheet for this product. OUR OBLIGATIONS UNDER THIS WARRANTY ARE LIMITED TO THE REPAIR OR REPLACEMENT (AT EVERPURE’S 

DISCRETION) OF THE FAILED PARTS OF THE WATER TREATMENT UNIT, AND WE ASSUME NO LIABILITY WHATSOEVER FOR DIRECT, INDIRECT, INCIDENTAL, 

CONSEQUENTIAL, SPECIAL, GENERAL OR OTHER DAMAGES. 
Some states do not allow the exclusion of implied warranties or limitations on how long an implied warranty lasts, so the above limitation may not apply to 

you. Similarly, some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This 

warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Consult your telephone directory for your local 

independently operated Everpure dealer, or write Everpure for warranty and service information.

Содержание EV3034-83

Страница 1: ...NPT male 3 4 NPT male Max Flow Rate 10 gpm 10 gpm 10 gpm Min Pressure 10 psi 10 psi 10 psi Max Pressure 90 psi non shock 100 psi non shock 100 psi non shock Max Temperature cold water use only 100 F 38 C 100 F 38 C 100 F 38 C Shipping Weight 321 2 pounds 28 pounds 35 pounds Operating Weight 411 2 pounds 68 pounds 133 pounds Part Number EV9100 24 EV9336 50 EV9336 51 The indention system employed in...

Страница 2: ...ll threaded connections 5 Install a 3 4 NPT x 3 4 barb connector into the the outlet tee of the pre filter and the inlet water ball valve on the high flow filter system 6 Measure distance between the barbs on the connectors and cut tubing not supplied to this length plus an additional 2 Slide two tubing clamps not supplied onto the tubing and install the tubing ends fully onto the connector barbs not...

Страница 3: ...ssure from the system using the flushing valve on the high flow filter system The extra capacity 12 gallon surge tank weighs 133 pounds and the standard 5 gallon tank weighs 68 pounds when full If the installation location in not on the floor be certain its stand shelf platform is capable of safely supporting this weight 3 Select a suitable location near the high flow filter system not to exceed maximum...

Страница 4: ...sign guidelines This warranty will not apply if the unit has been modified repaired or altered by someone not authorized by Everpure If a part described above is found defective within the specified period you should notify Everpure technical service at the phone number listed below Any part found defective within the terms of this warranty will be repaired or replaced at Everpure s discretion by yo...

Отзывы: