EverHot 647270, Руководство пользователя и инструкции по установке

Страница: 41 / 48

LIGHTING THE WATER HEATER
41
LIGHTING INSTRUCTIONS
Using the gas control, light the water heater as follows:
1. Stop , read the
“Safety Information”
on page 40.
2. Remove the access cover.
3. Depress the GAS KNOB slightly
and turn fully clockwise so the white
dot “

” (off position) faces the front,
aligning with gas knob position
indicator.
4. Wait five (5) minutes so any build
up of unburnt gas can escape. If
you then smell gas, stop and follow
“C” in the
“Safety Information”
on
page 40. If you do not smell gas,
proceed to step 5.
5. Depress the GAS KNOB slightly
and turn anticlockwise so the red
star “ ” (pilot position) faces the
front, aligning with gas knob
position indicator.
6. Depress the GAS KNOB fully (until the red star disappears below the
housing) and after 20 seconds, whilst keeping the GAS KNOB depressed,
repeatedly press the igniter button (for up to 40 seconds) until the pilot
flame ignites. The igniter is a red button located below and to the right of
the gas control.
Warning: Keep your face clear of the combustion chamber opening
while pressing the igniter.
Note: It is not possible to depress the GAS KNOB fully if the gas control
has activated its safety shut-off feature. In this case, wait 5 minutes for the
gas control to reset (this allows for any unburnt gas to escape).
7. Keep the GAS KNOB depressed for a further 20 seconds and then
release.
8. Depress the GAS KNOB slightly and turn it anticlockwise so the red line
“
l
” (ignition position) faces the front, aligning with gas knob position
indicator, and hold there for 5 seconds.
9. Release the GAS KNOB (the GAS KNOB will automatically turn to the red
flame “ ” (on) position), and listen for the burner noise.
gas control