Top view
Side view
Fig. C
9. After you finish shaping the tree, slightly upsweep all branch tips for a uniform look. Shift branches to fill any gaps. Your
Christmas tree is now complete and ready to be decorated.
8. Begin to shape the branches and tips working from the bottom to the top. Start with tips furthest from the pole and fan
out from the side before moving towards the middle of the branch. (See Fig. C)
1. Remove all ornaments and decorations. For pre-lit trees, first unplug adaptor from the wall outlet and then disconnect light
extension cord between each section of the tree.
2. Disassemble the tree from the top to the bottom. Start with the tree top and gently lift straight up to remove from section
below and fold all branches toward the pole.
3. In case of difficulty separating the tree pole (trunk), apply a small amount of lubricant at the joint and rotate the upper
pole in both directions. Lift up the upper pole again.
4. Continue by gently lifting straight up each section(s) from the section below and fold all branches toward the pole until
the bottom section is removed from the tree stand.
5. Carefully place all tree sections into shipping box and tape it shut.
6. When not in use, please store your tree in a cool, dry place away from sunlight. Exposing your tree to excessive heat or
humidity may damage your tree.
STORAGE INSTRUCTIONS
For pre-lit trees, if the tree does not illuminate
1. Please check to make sure that all plugs are properly connected and adapter is plugged into the wall outlet.
2. Check for loose connection between light string plugs and extension cords.
3. Please check for loose, broken or missing light bulbs and replace as needed.
Loose hinge pins
1. Extra hinge pins are included for repairing the hinges.
Place the branch into the slot of the bracket.
2. Insert a new hinge pin through the hole and secure
using the retainer washer. (See Fig. E)
TROUBLESHOOTING TIPS
Each tree includes hinge pins/washers, and for pre-lit trees spare bulbs are also included.
If extra parts are needed, please contact our customer service center.
SPARE PARTS
Fig. E
2
Press the Selector Button to select from the 7 preset light effects in the following sequence:
1. Steady Glow 2. Slow Fading 3. Fast Fading 4. 3 Speeds Fading
5. Slow Blinking 6. Fast Blinking 7. 3 Speeds Blinking
OPERATING INSTRUCTIONS
You can customize the light functions by using either the Light Controller or the Remote Control.
1. Before using the Remote Control, remove the insulation tab on its rear.
2. Press the Selector Button once on either control and wait for a second to enjoy light effects in the pre-programmed sequence.
There are 5 brightness levels. Simply press the controller buttons to
increase or decrease the brightness to your liking.
Default Timer Function:
Lights stay ON for 8 hours and then turn OFF for 16 hours. Timer function will restart when
any control button is pressed or main power supply to the lights is reconnected.
Memory Function:
If you unplug and reconnect the product to the power outlet, the product will resume
the last light effect and brightness level that was selected before the power was cut out.
Insulation Tab
Remote Control
Light Controller
Selector
Button
