Everglades EVCO1011, Руководство пользователя

Страница: 51 / 78

Brief introduction Reversing the door
The side at which the door opens can be
changed from the right side (as supplied) to the
left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it’s back in
order to gain access to the base, you should rest
it on soft foam packaging or similar material to
avoid damaging the cooling pipes at the rear of
the refrigerator.
1. Remove the upper hinge cap (7).
2. Remove the two screws blot (6) that connect
the upper hinge (5) on the right side of the
cabinet top.
3. Carefully lift the door and place it on a padded
surface to prevent scratching.
4. Remove the plug (9) and transfer it to the
uncovered hole on the right side of the unit.
Be sure to press the button firmly into the hole.
5. Remove the two screws (7) that hold the lower
hinge (2) on the right side of the unit.
6. Remove the screw-type leveling front leg (4)
and transfer it to the right side as shown in the
adjacent figure.
7. Set the door into it’s new place making sure the
pin enters the bushing at the lower frame section
(hole).
8. Secure the upper hinge (5) previously removed
in step 3 on the left side of the unit. Make sure the
pin enters the bushing on the upper frame
section (hole).
9. Loosely secure the lower left hinge (2) and do
not tighten the bolts until the door is in the closed
position and leveled.
10. lnsert the plug (9) on the uncovered holes
(right side).
11. Replace the upper hinge cap (7).
6
Screw Bolt
7 Upper Hinge Cap
8 Shaft Sleeve
9 Plug
1
Screw
2 Low Hinge
3 Adjustable Low Foot
4 Adjustable High Foot
5
Upper Hinge
13